Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wellborn Driveway & Pavers: The Los Angeles Owner’s Guide
If you have a Wellborn driveway or paver surface that’s cracking, sinking, or pulling apart at the edges, we stock the compatible replacement materials and install them throughout Los Angeles. A typical paver driveway repair or spot replacement runs $826 to $2,360 for smaller sections, while a full paver driveway installation in Los Angeles lands between $8,260 and $21,240 depending on square footage and access. Most owners call us after one bad rain season: water finds its way under the pavers, the base washes out, and suddenly there’s a low spot where the car hits every morning.
Wellborn’s name is best known in cabinetry, but the same manufacturing discipline shows up in their hardscape and paver lines: tight dimensional tolerances, uniform color blends, and pavers that don’t chip at the corner the first time you turn a wheel on them. When one section fails, it’s rarely the paver itself. It’s almost always what’s underneath it.
We’re an independent Los Angeles service provider, not a Wellborn dealer or affiliate. What that means for you: we match the part, we don’t upsell the brand.
Which Wellborn Models This Applies To
Wellborn driveway and paver products fall into three broad lines you’ll see around Los Angeles: their Heritage Brick series (classic 4×8 clay-style pavers, most common in older Los Angeles neighborhoods like Silver Lake and West Adams), the StoneCrest series (larger-format 12×12 and 16×16 pavers used on driveways and walking paths), and the PermaEdge border system (the interlocking edge restraints that hold the whole field together).
The compatibility gotcha most homeowners hit: Heritage Brick pavers from a pre-2018 Wellborn run are 60mm thick, while current production runs 50mm. Mix them on a driveway without grinding the base or adding a thin setting bed and you’ll feel the height difference underfoot immediately. We carry both thicknesses on the truck and measure before we quote, so you’re not paying for a mismatched repair that looks fine for six months and then shows up as a trip hazard.
For the StoneCrest line, the color blend code is stamped on the underside of the paver, not the top. If your driveway was installed more than five years ago, sun fading in Los Angeles has shifted the surface color enough that a brand-new paver will look brighter. We order from aged stock when we can, and when we can’t, we’ll tell you before we install, not after.
OEM Wellborn pavers are the cleanest match. Quality aftermarket equivalents from Belgard and Unilock run 15 to 20 percent less and hold up well in Los Angeles, but the texture profile differs slightly on the StoneCrest line. If the repair is in a low-visibility area like a side yard, aftermarket is a smart way to save. If it’s the front driveway apron, we recommend staying OEM for a clean match. We’ll show you samples of both before committing.
Styles & brands we work with
Signs Your Wellborn Driveway & Pavers Is Failing
- A paver sinks an inch or more when you step on it. The base underneath has washed out or was never compacted properly. In Los Angeles, this is most common on driveways with a slope, where irrigation runoff or gutter overflow cuts a channel under the pavers during winter rains. Leveling the paver without fixing the drainage means you’ll be back in the same spot next season.
- Gaps between pavers are widening, especially near the edges. The PermaEdge border restraint has loosened or cracked, and the field is slowly spreading toward the weakest point. You’ll see it first where the driveway meets landscaping, since root growth from mature Los Angeles trees pushes constantly against the edge.
- White haze or flaking on the paver surface. This is efflorescence, water migrating through the paver and leaving mineral salts behind. It’s common in coastal Los Angeles neighborhoods where salt air accelerates the cycle. It doesn’t mean the paver is structurally shot, but it means the paver’s protective sealer has worn through.
- Cracked pavers in the wheel tracks only. This is load failure, not age. The base wasn’t rated for vehicle weight, or the pavers are 50mm when the driveway really needed 60mm for the traffic it gets. We see this regularly in Los Angeles on driveways that originally served a sedan and now park a pickup or an SUV.
- Standing water after rain, long after the rest of the driveway drains. The driveway has lost its slope or the base has settled unevenly. Pooling water in Los Angeles is a fast track to further base erosion, and it’s the single most reliable predictor that the damage will spread if left alone.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what Wellborn driveway and paver work runs in Los Angeles, installed:
- Spot paver repair (1 to 10 pavers, base touch-up): $826 to $2,360
- Border/edge restraint replacement (per 20 linear feet): $413 to $945
- Full paver driveway installation: $8,260 to $21,240
- Paver patio installation: $4,130 to $12,980
- Driveway replacement (any paver system, tear-out included): $5,900 to $16,520
The range comes down to three things: how much base material has to be excavated and re-compacted, how hard the access is (tight Los Angeles hillside driveways with no room for equipment push the labor up), and whether we’re matching existing Wellborn pavers or installing a full new field. Every quote includes parts, labor, haul-off of the old material, and base prep. We put the price in writing before any work starts. If we find hidden damage when we open the base, we stop and show you before spending another dollar, no surprise invoices.
All paver repair and installation work carries our 365-Day Done Right Promise. If the repair settles, shifts, or fails within a year from the completion date, we return and fix it at no cost. No dispute process, no conditions.
DIY or Call Us?
There’s a middle ground here that’s worth knowing. You can absolutely handle the diagnosis side yourself: walk the driveway after rain and mark the low spots, note where water pools, and check whether paver gaps are widening at the edges. That saves you time on the phone and helps us quote faster.
What goes wrong with DIY on paver repair: pulling up one paver without the right extraction tool chips the corners of the two pavers next to it, and now your one-paver repair is a five-paver repair. Re-setting a paver on a thin bed of bagged sand from the home center works for about four months in Los Angeles until the first rain softens the base again. And if the issue is drainage related, which it usually is on sloping lots, no amount of paver swapping fixes the underlying grade problem.
The honest answer: if it’s a single paver and the base underneath is firm, a careful homeowner can handle it. If it’s sagging, spreading, or water-related, call us at (213) 632-5711. We’ll assess the base, give you a written price, and tell you what’s actually worth fixing now versus what can wait.
FAQs
A properly installed Wellborn paver driveway lasts 25 to 40 years in Los Angeles, with the paver itself rarely being the failure point; the base and edge restraints are what typically need attention at the 10 to 15 year mark. Sun exposure and salt air in coastal zones will fade surface color and wear sealer faster than inland areas. Call (213) 632-5711 if your driveway is showing its age sooner than that, and we’ll tell you whether the problem is the pavers or the base.
No, a cracked paver can’t be meaningfully repaired; the structural integrity is gone and any patching compound will fail within a season of Los Angeles heat and rain cycles. The good news is that single-paver replacement is usually under $100 in materials, and the labor is the bulk of the cost. Call (213) 632-5711 for an exact quote on your specific paver and count.
A spot repair of 1 to 10 pavers takes half a day to a full day on site, including base touch-up and edge re-setting. A full driveway installation or replacement typically runs two to four days, depending on the excavation depth and how much old base material has to be hauled out. We’ll give you a written schedule along with the written price before work starts.
We stock Wellborn Heritage Brick pavers in both 50mm and 60mm thicknesses and StoneCrest pavers in the common Los Angeles color blends; specialty colors or aged-stock matches may take a few days to source. We also carry compatible aftermarket pavers from Belgard and Unilock, along with KraftMaid, Cambria, and Silestone materials for interior work, so most jobs can be completed without a second trip. Call (213) 632-5711 and we’ll check stock against your specific paver before you commit to anything.
Know who’s coming, know what it costs, know it’s guaranteed, everything else is just noise. Isaac Pruett sees more driveways in Los Angeles fail from bad base prep than from bad pavers, and we’ve never fixed a base problem in one visit by pretending it was a paver problem. Call (213) 632-5711 for a free estimate, and you’ll get a written price before any work starts.
Written by Isaac Pruett, Owner, Mason Remodeling Co at Mason Remodeling Co Los Angeles, serving Los Angeles and nearby areas.
